Variable height as input for member

Join the discussion in our Structural Analysis Software forum. Publishing your message in English will result in a higher response rate.

Moderators: Rudi Vanmechelen, Mischa, Ing. R. Engelen

Variable height as input for member

Postby JS_Safe » 21 Sep 2020, 12:09

Hi All,

For a work I need to calculate scaffolding in different configurations (e.g. stand height, stand spacing, amount of braced stands, etc.).

Because a lot of the same configurations are used, we want to make tables in which the capacity of the configurations can be checked. To make these tables, a lot of configurations need to be calculated under different loadings. The configurations mainly differ in height. It would save a lot of time if I can set a variable height for members. To be more precise, is it possible to give a member a variable height 2000mm to 4000mm with steps of 200mm?

Hope you can help!
JS_Safe
 
Posts: 1
Joined: 21 Sep 2020, 11:42

Return to SCIA Engineer (English)



Who is online

Users browsing this forum: No registered users and 4 guests

About this forum

Welcome to this SCIA Engineer forum and read here for more info on Structural Analysis Software.